When you have to go up or down steps, you will need to make some custom cuts to change the elevation of the fence. (SEE STEP 4) ***NOTE: YOU MAY WANT TO ORDER EXTRA POLES AS YOU WILL NEED THEM FOR THE CUSTOM CUTS.
We recommend starting your layout at the bottom step as shown below. This minimizes the amount of custom cuts you will need to make. When marking, you want the center of your hole that is on the base of the step to be 1" away from the step and the hole that is on the step to be 1 1/2" away from the edge of the step, totaling 2 1/2".
When latching your sections together, you will have to stagger the latches as shown below. Simply remove the screw that aligns with the latch, or simply drill a hole where required.